How to use a showzer dog wash
Hello and welcome to Showzer.
The cost of this service is $12 per 10 minutes.
When you are ready and have listened to all instructions, please tap your card or phone device onto the card reader. This will start the 10-minute cleaning cycle. You will hear a beep, signaling your 10 minutes have commenced. You can add another 10 minutes when the time is up by tapping your card or phone device onto the card reader again.
You will find a bracket on the right wall at the height of the card reader to hang your harness and leash.
Step 1
Please secure your dog into the tub entering through the door on the Showzer to your left. A tether is provided in the left back corner of the tub.
Step 2
Make your treatment selection:
You will locate the selection buttons to the left of the card reader.
The top single button is the rinse button. This will activate the plain water. You can press it to stop any other selections.
The 2nd row of buttons starting from left to right is:
- Shampoo
- Conditioner
- Flea Control Solutions
The 3rd row from left to right is:
- Blow Dry Hi speed
- Blow Dry Low speed
- Tub Disinfect
Step 3
Remove the dog from the tub.
Rinse the tub with Tub Disinfect. This is only to be used at the end of the cycle once you have removed the dog from the tub.
Tidy hoses by hanging them over the bracket on the right-hand side of the tub, and close the tub door.
Make sure your dog is secured and leave through the same gate you entered through.
Thank you for using Showzer Dog Wash.